It is currently Tue Jan 23, 2018 10:28 pm
LDR plasma table discussion forum
4 posts • Page 1 of 1
- Posts: 11
- Joined: Sun May 14, 2017 7:59 pm
I am new to burning, our 5x10 with rotary, and scribe should be here by the middle of the month. Any advice for the new guy? We will be making brackets for bumpers 1/2" plates. Coping cuts for upright pieces. We have bend tech program, but I am not to happy, because we have square tubing to cut, and burn holes into and the program is not working out. Or I am to dumb to figure it out. Any help would be great !!!
- Posts: 845
- Joined: Tue Feb 28, 2012 6:47 pm
Duh! I should have noticed which sub forum this is in.....LDR. Dan can help you address the square tube cutting issue. LDR has more experience than most with building and using rotary plasma cutting. Bendtech may or may not be the answer for non-round cutting.
Who is online
Users browsing this forum: No registered users and 1 guest