THC GOES UP, NOT DOWN?

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
Doc Hollywood
2.5 Star Member
2.5 Star Member
Posts: 148
Joined: Fri Jun 28, 2013 4:36 pm

THC GOES UP, NOT DOWN?

Post by Doc Hollywood »

HI Guys,
Tried searching this, i think it's been covered but i cannot find the answer....
Cutting 16ga art file, material starts to warp, (i usually do not have any material warping btw) and thc brings torch up as it warps. (cool) When torch travels over non-warped up area THC does not lower torch back to correct cut height. Just keeps climbing, as does measured voltage.
What am i missing here? Thanks!
Doc
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1352
Joined: Tue Feb 28, 2012 6:47 pm

Re: THC GOES UP, NOT DOWN?

Post by tcaudle »

Turn off TIp Saver. Its locking the torch . The rest of the answer depends on the model of the LDR setup you have. Give Dan a call they are really good at soriting out cutting problems on their equipment.
Doc Hollywood
2.5 Star Member
2.5 Star Member
Posts: 148
Joined: Fri Jun 28, 2013 4:36 pm

Re: THC GOES UP, NOT DOWN?

Post by Doc Hollywood »

Thanks Tom! I'll call him Monday :-)
Post Reply

Return to “Various Manufacturers Forum”