It is currently Fri Sep 22, 2017 11:21 am

 

Table arriving later this Month, advice ?

LDR plasma table discussion forum
pitbumpers
Posts: 5
Joined: Sun May 14, 2017 7:59 pm
Contact:

Table arriving later this Month, advice ?

Postby pitbumpers » Sat Sep 02, 2017 10:24 am

I am new to burning, our 5x10 with rotary, and scribe should be here by the middle of the month. Any advice for the new guy? We will be making brackets for bumpers 1/2" plates. Coping cuts for upright pieces. We have bend tech program, but I am not to happy, because we have square tubing to cut, and burn holes into and the program is not working out. Or I am to dumb to figure it out. Any help would be great !!!

tcaudle
Posts: 729
Joined: Tue Feb 28, 2012 6:47 pm
Contact:

Re: Table arriving later this Month, advice ?

Postby tcaudle » Sat Sep 02, 2017 1:16 pm

Without knowing more about your table and how the rotary is implemented and controlled its not possible to offer possible solutions.

tcaudle
Posts: 729
Joined: Tue Feb 28, 2012 6:47 pm
Contact:

Re: Table arriving later this Month, advice ?

Postby tcaudle » Sat Sep 02, 2017 1:20 pm

Duh! I should have noticed which sub forum this is in.....LDR. Dan can help you address the square tube cutting issue. LDR has more experience than most with building and using rotary plasma cutting. Bendtech may or may not be the answer for non-round cutting.

pitbumpers
Posts: 5
Joined: Sun May 14, 2017 7:59 pm
Contact:

Re: Table arriving later this Month, advice ?

Postby pitbumpers » Mon Sep 04, 2017 9:32 am

Thanks !!


Return to “LDR Motion Systems”

Who is online

Users browsing this forum: No registered users and 1 guest