Page 1 of 1

Our Youtube Channel

Posted: Sun Nov 12, 2017 9:07 pm
by BTA Plasma
Please see our youtube channel for some quick software training videos. We have many videos in the works.

https://www.youtube.com/channel/UC8H3H9 ... Wmcbl7Vh-Q

Re: Our Youtube Channel

Posted: Mon Nov 13, 2017 1:07 pm
by _Ogre
nice work BTA :mrgreen:

if you'd like to post our rotacut videos on your channel, you are welcome to use them
only 2 with low res but they get the point across

https://www.youtube.com/watch?v=Ilc_ldF7eLE

https://www.youtube.com/watch?v=8D7JpWrDDaM

the rotocut is the reason we went with bta

Re: Our Youtube Channel

Posted: Mon Nov 13, 2017 4:17 pm
by Scratch
BTA Plasma wrote:Please see our youtube channel for some quick software training videos. We have many videos in the works.

https://www.youtube.com/channel/UC8H3H9 ... Wmcbl7Vh-Q


Is this Matt from Bulltear? The guy from Minnesota?
I think I might have made you some parts before you got your tables...?

Re: Our Youtube Channel

Posted: Mon Nov 13, 2017 4:20 pm
by BTA Plasma
Matt here. I am one of the folks that use the BTA plasma profile. How are you buddy? Machine been cutting good for you? Ready for an update?

Re: Our Youtube Channel

Posted: Mon Nov 13, 2017 4:22 pm
by BTA Plasma
_Ogre wrote:nice work BTA :mrgreen:

if you'd like to post our rotacut videos on your channel, you are welcome to use them
only 2 with low res but they get the point across

https://www.youtube.com/watch?v=Ilc_ldF7eLE

https://www.youtube.com/watch?v=8D7JpWrDDaM

the rotocut is the reason we went with bta

Thank you! Yes that rotary that we built was the base idea for the Rotacut II with a 2,5" through hole.

Re: Our Youtube Channel

Posted: Tue Nov 14, 2017 12:35 pm
by _Ogre
our cnc plasma cutting is 99% exhaust work: tube copes, holes in tubes and flanges, thus we need the inside of the tube as clean as the outside
if you look at the video, notice we use a coolant pump in the center hole of the rotacut chuck to keep dross out of the inside of the tube
coolant (table water) pump is a $15 aquarium pump that we've had since we set the table up 5 years ago
rotacut is the main use/purchase for our table, anything beyond that is a bonus, now we cut a lot of ss flanges and custom turbo flanges
works great for the investment we have in it

thanks matt for a great product :mrgreen:

Re: Our Youtube Channel

Posted: Thu Nov 16, 2017 11:03 am
by BTA Plasma
Yes that was a very good idea the coolant pump.