It is currently Mon Jan 22, 2018 11:11 pm

 

Adding an Air scribe to a Koike Millennium Table

Questions and information relating to plate markers should be posted in this forum.
solomanb
Posts: 74
Joined: Fri Jul 01, 2011 10:47 pm
Location: Tulliby Lake Alberta Canada

Adding an Air scribe to a Koike Millennium Table

Postby solomanb » Thu Oct 22, 2015 12:22 am

Hello all
I was wondering if anyone has installed an air scribe to a Kioke Millennium table. It is equipped with an older Promotion Controller maybe 2007 or 2008.
It has IHC as well. Documentation shows 24 Volts DC for the lifter As I have posted in earlier the only issues I have had were with the linear slides on the lifter and some internal issues within the controller(Memory Card becoming unseated). I would like to mark some plates before cutting so assembly will be easier, I am looking at some 3D projects that require 500+ parts. I plan on purchasing a kit with an air lifter/solenoids/filters etc. and purchase the scribe from a local CP dealer.
This is a wonderful site with lots of diverse information.
Thanks Solomanb

tcaudle
Posts: 845
Joined: Tue Feb 28, 2012 6:47 pm

Re: Adding an Air scribe to a Koike Millennium Table

Postby tcaudle » Thu Oct 22, 2015 7:10 pm

90% of air scribe is in CAM . You have to have a CAM program that provides a marker tool and lets you define the objects (contours) to be engraved/marked . That tool has to be able to call an output to turn on the engraver . Unless you are going to swap out the plasma torch with the plate marker you also have to be able to define offsets. Time to hit the manuals on your CAM program with that table.


Return to “Plate Markers/Air Scribes”

Who is online

Users browsing this forum: No registered users and 1 guest