Search found 5 matches

by Njcnc
Fri Sep 15, 2017 9:48 pm
Forum: Hypertherm Plasma Cutters
Topic: Powermax 1000 howl when air flowing
Replies: 4
Views: 62

Re: Powermax 1000 howl when air flowing

Air regulator vibrating? I have one at work that does this occasionally. Not even 30 seconds after I posted this I was reading another post about input pressure needs to be between 90-120psi. I went out to the garage and had my air on full blast somewhere between 140psi and 160psi from the compress...
by Njcnc
Fri Sep 15, 2017 9:37 pm
Forum: Hypertherm Plasma Cutters
Topic: Powermax 1000 howl when air flowing
Replies: 4
Views: 62

Powermax 1000 howl when air flowing

Picked up a new to me powermax 1000 the other day with a handful of extra consumables for $500 off CL. I planned on upgrading to the duramax torch and it would eventually make its way on to my plasma table but i'm concerned. I'm getting this odd loud howling noise from the machine at times when air ...
by Njcnc
Sat Sep 02, 2017 1:44 pm
Forum: Everlast & Longevity Plasma Cutters
Topic: Everlast CNC Port Errata - How it really works
Replies: 9
Views: 284

Re: Everlast CNC Port Errata - How it really works

Wanted to post back that I went ahead and did the mod pictured above. I have a powerplasma 60s and the board looked a tad different but found the same thing. Pin 4 at the plug is a black wire going to pin 7 on the board. Pin 6 at the plug is a red wire going to pin 5 on the board. Jumped the resisto...
by Njcnc
Tue Aug 29, 2017 11:53 am
Forum: Everlast & Longevity Plasma Cutters
Topic: Everlast CNC Port Errata - How it really works
Replies: 9
Views: 284

Re: Everlast CNC Port Errata - How it really works

Oh man, thank you both so much for this info. I have been running Everlast plasma on two separate builds now with raw arc voltage and Proma THCs. I hated having to run raw arc voltage out of the until to the Proma. I'm heading home today after work to jumper that board and see if the Proma will read...
by Njcnc
Tue Aug 29, 2017 11:50 am
Forum: DIY Plasma Table & Accessory Discussion Forum
Topic: Gcode Error, Help!
Replies: 10
Views: 381

Re: Gcode Error, Help!

Can you post a snippet of your Gcode as well as the sheetcam post processor you would like to use? I use that Toma Linuxcnc config exclusively and it works great for me. The post processors will be incredibly simple since the touch off, pierce height and delay are all done automatically off of a sin...

Go to advanced search